Hello,
J'ai le même défaut que toi :
ECM-930A Capteur de position de l'embrayage - Signal défectueux
Voici ce que j'ai trouvé sur le net :
ECM-930A Clutch pedal sensor, faulty signal.
On a vehicle with a manual transmission the ECM calculates the gear being used, by calculating the ratio between current engine speed and road speed and matches that ratio to one of the 6 possible ratios stored in the ECM. If there are 5 gear changes in the same driving cycle where the clutch pedal is not pressed more than 10%, a fault is detected and the DTC ECM-930A posted, and cruise control will be denied for the remainder of the drive cycle.
Downloading the latest ETS software will have no effect on this DTC. The clutch position detected by the sensor should be checked against pedal movement using VIDA.
ECM-9300 Clutch pedal position sensor
Signal too high
Fault trace signal wire shorted to supply (>4.771V) using VIDA.
Signal too low
Fault trace signal wire shorted to ground (< 1.66V) using VIDA.
Faulty signal
This monitor was intended for production line verification only and is not tolerant of wear over time. Resulting in unnecessary DTC's and cruise control denied by the ECM for the remainder of the driving Cycle.
Downloading the Latest ETS Software will remove the assembly fault monitor as the cruise will disconnect with detected gear ratio, but the signal too high/low will remain.
J'ai le même défaut que toi :
ECM-930A Capteur de position de l'embrayage - Signal défectueux
Voici ce que j'ai trouvé sur le net :
ECM-930A Clutch pedal sensor, faulty signal.
On a vehicle with a manual transmission the ECM calculates the gear being used, by calculating the ratio between current engine speed and road speed and matches that ratio to one of the 6 possible ratios stored in the ECM. If there are 5 gear changes in the same driving cycle where the clutch pedal is not pressed more than 10%, a fault is detected and the DTC ECM-930A posted, and cruise control will be denied for the remainder of the drive cycle.
Downloading the latest ETS software will have no effect on this DTC. The clutch position detected by the sensor should be checked against pedal movement using VIDA.
ECM-9300 Clutch pedal position sensor
Signal too high
Fault trace signal wire shorted to supply (>4.771V) using VIDA.
Signal too low
Fault trace signal wire shorted to ground (< 1.66V) using VIDA.
Faulty signal
This monitor was intended for production line verification only and is not tolerant of wear over time. Resulting in unnecessary DTC's and cruise control denied by the ECM for the remainder of the driving Cycle.
Downloading the Latest ETS Software will remove the assembly fault monitor as the cruise will disconnect with detected gear ratio, but the signal too high/low will remain.