03-04-2016, 21:22:42
Si quelqu'un peut me traduire ca car le traducteur reverso est un peu vague ... je comprends bien la premiere phrase mais pas du tout la deuxieme ...
"my after thought: it's doable but by no means easy. It's essential to measure TPS output voltage before you do the swap and to achieve the same or very close voltage with the new Hall-effect TPS.
I would also strongly advice to connect the new TPS by soldering additional electric wiring between TPS and ETM electronics. It's much more dependable then soldering terminal to terminal (the OEM TPS was spotwelded to the ETM terminals! a much stronger connection then a soldered connection)"
"my after thought: it's doable but by no means easy. It's essential to measure TPS output voltage before you do the swap and to achieve the same or very close voltage with the new Hall-effect TPS.
I would also strongly advice to connect the new TPS by soldering additional electric wiring between TPS and ETM electronics. It's much more dependable then soldering terminal to terminal (the OEM TPS was spotwelded to the ETM terminals! a much stronger connection then a soldered connection)"
http://www.youtube.com/watch?v=ggCCFUpE69c